Advertisement
Model 11869A
Manual Backdating Changes
Page 8-7, Figure 8-3:
Delete W12 AUX OUTPUT
(OPT.
006 REAR PANEL).
Page 8-24, Figure 8-11:
Replace Figure 8-11 with
11869A Major Assemblies
from this section.
CHANGE B
Page 6-6, Table 6-2:
Change W2 HP and Mfr. Part Number to 11869-60002, CD6.
CHANGE C
Page 1-4, Table 1-1:
In the paragraph headed
Plug-In Compatibility with the
11869A/8350A,
delete the following:
''The Modulation Select Switch on the 11869A Connector Board
selects the correct path for the squarewave 'modulation signal
from the 8350A for use with each Plug-In.'1
Page 2-7, Figure 2-5:
Delete Item 3,
Setting the Modulation Select Switch,
and Table 2-1,
Modulation Select Switch Settings.
Page 3-1, Paragraph 3-2:
Change to read as follows:
''The HP 11869A RF Plug-In Adapter has only one operating
control, the Plug-In Identification Switch A1S1 located on the
top panel. This switch is set prior to installation. The
setting varies according to the individual Plug-In to be
installed.
(See Section II of this Manual for
instructions)'
Page 3-1, Paragraph 3-3.
Delete the first sentence.
Page 6-5, Table 6-2:
Change A1J2 to HP Part Number 1200-0626 CD3 SOCKET-IC 20-CONT
DIP-SLDR.
Change A2 HP and Mfr. Part Number to 11869-60016 CD8.
Delete A2CR2.
Delete A2R9.
Delete A2S1.
Page 8-18, Figure 8-8:
Replace Figure 8-8 with the
A2 Connector Board Parts location
Diagram
(CHANGE C)
in this section.
Page 8-19
Under
A2 CONNECTOR BOARD THEORY,
change the second sentence of the
second paragraph to read:
''Other signals are routed through the Level Shifter circuit.''
Change
INTERFACE AND MODULATION SELECT
to
''INTERFACE''.
Under
INTERFACE
(C)
Delete all except the first paragraph.
7-3
Advertisement
