Advertisement
Model 11869A
Installation
Figure 2-5.
Installation (3 of 6)
4*
Adjusting the Clamp Position Plate
The clamp position plate on the bottom of the 11869A can be moved
backward or forward to adjust the effective length of the clamp
that attaches the Adapter to the Plug-In. Check the CLAMP ADJUST
list beside the position plate for the correct placement of the
position plate for the Plug-In to be installed. To move the clamp
position plate, loosen the four retaining screws
(Figure 2-7),
slide the plate to the proper position, and re-tighten the
retaining screws.
5.
Extending the Clamps
Extend the clamps on the top and bottom of the 11869A by turning
the clamp adjust knob according to the INSTRUCTIONS on the top
panel. Turn the knob to the TO DISCONNECT position.
POSITION
PLATE
'TO CONNECT'
POSITION
CLAMP ADJUST
KNOB
RETAINING SCREW
(4 PLACES)
CLAMP
(2 PLACES)
TO DISCONNECT'
POSITION
Figure2-7.
Clamp Position Plate
2-7
Advertisement
