5. TEST OPERATION / 試動
(1) •
Turn on the Main Water Valve.
•
Check if water leaks from the pipe line.
(1). •
擰開水道的主閥。
•
檢驗配管是否有漏水。
(2) •
Before switch on electricity, check the wiring.
•
Set the Miniature Circuit Breaker to "ON".
•
Set the ELB of the unit to "ON" (Push up the
Reset Lever)
•
Push the Test Button of the ELB Test Button.
•
It is normal if the ELB turns "OFF" (the RESET
Lever falls) and set the ELB to "ON" again.
(2) • 在還沒有接通電流時,檢查接線。
• 將電流回路切斷器設在"ON"的位置。
• 將ELB的開關轉換於"ON"(將復原控制棒)。
• 按下ELB的檢查處的試驗電鈕。
• 如開關之即斷電,則為之正常狀態(復原控制棒落下)
跟著ELB回復"ON"的位置。
(3) •
Open the Hot Water Faucet and set the power.
•
Set Power Selector Knob to LO,MED or HI.
When the ELB Lamp is light up, the hot water
will flow out.
(3) •
擰開熱水出口的水龍頭和置電量調整鈕。
•
置電量調整鈕設在 LO,MED 或 HI。
使到ELB和電量指示燈發亮,跟著流出熱水。
(4) Regulate the Hot Water Faucet so that the hot water
temperature becomes optimum.
•
Too hot
* Further open the Faucet.
* Check for clogging of the piping
•
Too cold
* Reduce the volume of water
(4) 調旋水龍頭的活栓,使到噴水到達最佳的溫度。
•
* 全開水龍頭。
噴水過熱
* 檢查水管有無阻塞。
•
* 擰閉水龍頭而縮小流量。
噴水過冷
Power Selector Knob
電量調整鈕
ELB Test Button
ELB 試驗鈕
Hot Water Faucet
熱水水龍頭
ELB RESET Lever (2pcs)
ELB 復原控制棒(兩個)
WARNING
In order to avoid a hazard due to inadvertent resetting of the thermal cut out,
this appliance must not be supplied through an external switching device,
such as timer or connected to a circuit that is regularly switched on and off
by the utility.
警告
為了避免因不慎按到重新設置熱能斷流器所造成的危險,
此花灑器禁止使用外加調節器,如定時器或連接至定時開關的電路。
WARNING
Do not switch on if the water in the unit became ice.
警告
當機體內的水結成冰時切勿啟動開關。
- 14 -
ELB Lamp
ELB 指示燈
ELB
POWER SELEC TOR
SUP ER POW
ER
MU LTI POI
NT
ELB CHE
CKE R
RE SE
T PU
SH UP
Filter Knob
過濾器鈕
Main Water Valve
水道的主水閥