Advertisement
Manual Version: 6P103-20130916
4.2 Removing the LST1FW3A1 (JG371A) module
1.
Use a Phillips screwdriver to loosen the captive screws at both sides of the module until all pressure
is released.
2.
Pull the ejector levers at both sides of the module outward, and pull the module along the guide
rails until it completely comes out of the backplane.
3.
Place the module on an anti-static workbench with the surface-mounted components up, or put it in
an anti-static bag.
4.
If no new module is to be installed, install a filler panel to prevent dust and ensure good ventilation
in the switch.
5 Logging in to the LST1FW3A1 (JG371A) module
Log in to the module through Open Application Platform (OAP).
Table 6 Log in to the module through OAP
Task
Log in to the module
through OAP.
NOTE:
Besides this login method, you can also log in to the firewall module through Web, Telnet, SSH, or console
port. For more information about these login methods, see
Guides
.
6 Software upgrade
You can upgrade the LST1FW3A1 (JG371A) module software through its console port or Ethernet ports.
The LST1FW3A1 (JG371A) module uses a different BootWare and system software image than the
switch. You can upgrade the system software image of the module by using the following methods:
6.1 Upgrading software in the Web interface
You can use the following default settings to log in to the Web interface through HTTP:
Username—admin
•
Password—admin
•
IP address of the Ethernet port GigabitEthernet 0/1—192.168.0.1/24.
•
To upgrade software in the Web interface, select Device Management > Software Upgrade from the
navigation tree, and perform related configurations on the page.
The software upgrade process takes some time. During the upgrade process, do not perform any
operation in the Web interface. Otherwise, software upgrade may be interrupted.
BOM: 3123A0MN
Command
•
In standalone mode:
oap connect slot slot-number
•
In IRF mode:
oap connect chassis chassis-number slot
slot-number
5
Part number: 5998-3444
Remarks
Available in user view of the
switch.
To return to the CLI interface of the
switch, press Ctrl+K.
HP VPN Firewall Appliances Configuration
Advertisement
