Table of Contents
Advertisement
19" Rack Cabinet & Brooks Loop Modules
5
5.1
Cabinet Overview
The Brooks 19" rack cabinets are designed to suit Brooks modular display / control
modules. The enclosures are available in the following cabinet size:
•
Large 22U enclosure 1050mm High x 600mm Wide x 250mm Deep, Figure 22
Small 13U enclosure 700mm High x 600mm Wide x 250mm Deep, Figure 23
•
•
Battery 6U enclosure 350mm High x 600mm Wide x 250 mm Deep, Figure 22 page
174 and Figure 23 page 175
Any combination of the three cabinet sizes can be manufactured. The battery 6U enclosure
is normally fitted below either of 22U or 13U enclosure to allow for larger batteries should
the need arises. Cabinets support optional side by side mounting for large systems.
When the battery enclosure is to be used with the 22U enclosure, the whole cabinet should
be mounted on a plinth on the floor such that the LCD display would be at the eye level.
These addressable FT1020G3 19" rack panels are fully customisable to site requirements
and its racks are modularised in design.
A possible layout for FT1020G3 Mounted in 22U Cabinet is shown in Figure 7. Small
enclosure can also be used for FT1020G3 as shown in Figure 8 (for FT128), in this case,
the front 6U plate and display may replace FT128 display.
Figure 7 FT1020G3 Mounted in 22U Large 19" Rack Enclosure
28
Operation Manual
FT1020G3 Rev 2.10.4
Advertisement
Table of Contents
