Table of Contents
Advertisement
Parking Lot Sensor | PLS
2.3 Installation of the sensor base
To ensure safe installation:
Do not install the sensor core (black part) into the sensor base
(grey part) before the final installation of the sensor base on the
ground.
Do not screw the sensor base on the ground!
Do not drill holes in the base!
Do not bring a magnet near the PLS (this would power-on the
device).
Avoid uninstalling and reinstalling the sensor core after the initial
installation into the sensor base.
Do not open the sensor core!
The sensor base must be fixed to the ground (substrate such as concrete, asphalt) with a two-component adhesive
from a leading supplier (e.g., DELO®, 3M®, ...).
Customers have reported good experience with the following adhesive: DELO®-PUR 9692 (universal 2-component
polyurethane adhesive available in 50 ml and 200 ml cartridges).
Required material for installing the parking lot sensor
Figure 2
Material for attachment
1
Disposable gloves (protection against contact with adhesive)
2
Two-component adhesive
3
Adhesive press (these differ, depending on the cartridge size)
4
Mixing tube
5
Tape rule
6
Sensor base
7
Sensor core (sensor)
8
T20 screw
9
Sensor cap (sensor sealing cap)
10 Appropriate tool to clean ground surface (e.g., broom, air blower)
© Robert Bosch France SAS 2022. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the
event of application for industrial property rights. Data subject to change without notice. Printed in France, December 2022.
Precaution
4 | 18
Sensor Cap
Advertisement
Table of Contents
