Advertisement
Select the desired subtest number from the subtest menu and press Enter.
4.
The following message appears:
TEST LOOP
Selecting YES increases the pass counter by one each time the test cycle ends and
also restarts the test cycle.
Selecting NO returns the subtest menu to the Diagnostic Test Menu after the test
is complete.
NOTE: Use the left or right arrow key to select the option, YES or NO, and
use the up or down arrow key to move the highlight bar.
5.
The following message appears:
ERROR STOP :
Selecting YES stops the test program when an error is found and displays the
operation guide on the right side of the screen as shown below:
ERROR STATUS NAME
These three selections have the following functions respectively:
1:
Terminates the test program and exits to the subtest menu.
2:
Continues the test.
3:
Restarts the test from the error.
Selecting NO keeps the test running even if an error is found.
Press Enter to start the test program.
6.
Table 3-1 in Section 3.3 describes the function of each test on the subtest menu.
Table 3-2 in Section 3.15 describes each error code and its status.
110 Series
:
YES
YES
[[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
3-5
Advertisement
Related Manuals for Toshiba Satellite 110 Series
Related Products for Toshiba Satellite 110 Series
- Toshiba Satellite Radius 11 L10W-B
- Toshiba Satellite Radius 11 CL15W-C Series
- Toshiba Satellite Radius 11 L15W-C Series
- Toshiba Satellite Radius 11 CL1 C Series
- Toshiba Satellite Radius 11 L1 C Series
- Toshiba Satellite Radius 11 L10W-C Series
- Toshiba Satellite Radius 11 CL10W-C Series
- Toshiba Satellite Radius 11 CL10W-B