Table of Contents
Advertisement
STEERING / SUSPENSION
WARNING
Upon radius rod installation, test vehicle at low speeds
before putting into service.
REAR STABILIZER BAR REMOVAL
1. Lift and support vehicle by main frame.
2. Remove rear wheels nut and wheels.
3. Identify / mark top side of the stabilizer bar to
reference during installation.
4. Remove the fasteners retaining the stabilizer bar to
q
the linkage
on each side of the vehicle.
5. Remove the four fasteners
bar to the vehicle frame.
6. Remove the bushing brackets and bushings for ease
of removal.
7. Carefully remove the stabilizer from the LH wheel
well area of the vehicle.
8. Inspect the stabilizer bar for straightness. Inspect the
pivot bushings and replace if needed.
STABILIZER BAR INSTALLATION
1. Carefully install stabilizer bar through the LH wheel
well area.
Be sure fuel lines and shift cable are routed ABOVE the
stabilizer bar.
2. Fully install stabilizer bar, bushings, bracket and
bracket fasteners and stabilizer links. Center
stabilizer bar in the frame. Torque fasteners to
specification (see below).
3. Torque all fasteners to specification (see below).
4. Lubricate stabilizer bar pivot bushings via grease
fitting (fittings are accessible through skid plate).
8.20
w
retaining the stabilizer
NOTE
5. Install rear wheels and wheel nuts. Torque wheel
nuts to specification.
TORQUE
Rear Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)
Stabilizer Bar Mounting Bracket Bolts:
20 ft-lb (27 Nm)
Wheel Lug Nuts:
120 ft-lbs (163 Nm)
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
Advertisement
Chapters
Table of Contents
Troubleshooting
