Environmental Requirements - Huawei FusionPower6000 Maintenance Manual
Hide thumbs
Also See for FusionPower6000:
- User manual (130 pages) ,
- Product description (63 pages) ,
- Quick manual (12 pages)
Table of Contents
Advertisement
FusionPower6000
Maintenance Guide
Drilling Holes
Do not drill holes into the equipment. Doing so may affect the electromagnetic
shielding of the equipment and damage components or cables inside. Metal
shavings from drilling may short-circuit boards inside the equipment.
●
●
●
1.5 Environmental Requirements
Install the equipment in an area far away from liquids. Do not install it under
areas prone to condensation, such as under water pipes and air exhaust vents, or
areas prone to water leakage, such as air conditioner vents, ventilation vents, or
feeder windows of the equipment room. Ensure that no liquid enters the
equipment to prevent faults or short circuits.
General Requirements
●
●
●
●
●
●
●
●
Issue 02 (2022-07-18)
WARNING
Obtain consent from the customer and contractor before drilling holes.
Wear goggles and protective gloves when drilling holes.
When drilling holes, protect the equipment from shavings. After drilling, clean
up any shavings that have accumulated inside or outside the equipment.
WARNING
Do not install or run the equipment beyond the technical specifications.
Otherwise, its performance and safety will be compromised.
Do not install the equipment in environments with conductive metal scraps in
the air.
Do not install the equipment in an environment with direct sunlight, dust,
volatile gases, infrared and other radiations, organic solvents, corrosive
materials, or salty air.
Do not expose the equipment to flammable or explosive gas or smoke. Do
not perform any operation on the equipment in such environments.
Do not install, use, or operate outdoor equipment and cables (including but
not limited to moving equipment, operating equipment and cables, inserting
connectors to or removing connectors from signal ports connected to outdoor
facilities, working at heights, and performing outdoor installation) in harsh
weather conditions such as lightning, rain, snow, and level 6 or stronger wind.
If any liquid is detected inside the equipment, disconnect the power supply
immediately and contact the administrator.
To prevent fire due to high temperature, ensure that the ventilation vents or
heat dissipation system are not blocked when the equipment is running.
The equipment room should have good heat insulation, and the walls and
floor should be protected against moisture.
Copyright © Huawei Digital Power Technologies Co., Ltd.
1 Safety Information
17
Advertisement
Table of Contents
Troubleshooting
