Installing Or Replacing A Dvd-Rom Drive; Replacing The Internal Transcoder Device; Replacing Or Installing The Front Port Panel - Bosch DIVAR IP 6000 2U Installation Manual
Hide thumbs
Also See for DIVAR IP 6000 2U:
- Quick installation manual (28 pages) ,
- Quick installation manual (28 pages) ,
- Instruction manual (48 pages)
Table of Contents
Advertisement
DIVAR IP 6000 2U
3.4
Installing or replacing a DVD-ROM drive
The chassis models are not shipped with a DVD-ROM from factory as the OS is pre-installed on
the disk on module drive (DOM).
If you must install a new or replace a faulty DVD ROM, observe the following instructions.
To install or replace a DVD-ROM drive:
1.
2.
3.
4.
5.
6.
7.
3.5
Replacing the internal transcoder device
The chassis model includes an internal USB transcoder device.
Notice!
To replace or install the transcoder device, please apply to one of the Bosch RMA helpdesks.
3.6
Replacing or installing the front port panel
If you must install a new or replace a damaged front port panel, observe the following
instructions.
Bosch Sicherheitssysteme GmbH
1
DVD-ROM
Turn off the unit and if necessary, remove the unit from the rack.
Remove the chassis cover.
Unplug the drives power and data cables from the motherboard and/or backplane.
If you are adding a new DVD-ROM drive:
Remove the mini-bezel (grate) from the drive bay The bezel can be removed by pulling out
the hard drive beneath the DVD-ROM drive bay, then pulling the mini-bezel forward.
If you are replacing a drive:
Locate the locking tab at the rear (left hand side when viewed from the front) of the DVD-
ROM drive. Push the tab toward the drive and push the drive unit out the front of the
chassis.
Insert the new drive unit in the slot until the tab locks in place.
Reconnect the data and power cables.
Replace the chassis cover. replace the unit in the rack, if necessary, then turn on the
system.
2
Installation Manual
Chassis setup and maintenance | en
Front port panel
17
2014.01 | V2 | DOC
Advertisement
Table of Contents
