Table of Contents
Advertisement
CIP5000 series storage
Figure 4.5: System installed in rack
To install the enclosure hardware into a rack with the supplied rails:
1.
2.
3.
4.
4.3
Task 3: install disk drives
The CIP-5316W-00N and CIP-5424W-00N support SATA/SAS 3.5-inch hard disks.
4.3.1
Drive slot numbering
You can install any suitable disk drive into any slot in the enclosure.
Figure 4.6: Drive slot numbering for 3U models
Bosch Security Systems B.V.
Vertical rack post
Handles mount
outside the rack post
Check the fit of the rails in your rack system.
Adjust the length of the rails as needed.
–
The rear half of the rail slides inside the front half. The rail halves are riveted
together, so no adjustment screws are needed.
–
The front-left and front-right rail ends are labeled.
–
Be sure the front rail support is on the bottom facing inward.
–
All rail ends, front and rear, attach at the outside of the rack posts.
–
The guide pins at the rail ends align with the holes in the rack posts.
–
Use the attaching screws and flange nuts from your rack system. Tighten the screws
and nuts according to instructions for your rack system.
Place the enclosure hardware onto the rails.
Secure the enclosure hardware to the rack.
–
The unit attaches to the rack posts using the included screws and flange nuts.
–
One screw each side, in the upper hole only.
1
2
5
6
9
10
13
14
Quick installation guide
Mounting rails mount
outside the rack post
3
4
7
8
11
12
15
16
Setup tasks | en
13
2019-10 | V01 | F.01U.380.028
Advertisement
Table of Contents
