Bosch Active Line Owner's Manual page 21
Hide thumbs
Also See for Active Line:
- Original operating instructions (212 pages) ,
- Manual (179 pages) ,
- Original instructions manual (160 pages)
Table of Contents
Advertisement
Technical Data
Drive unit
Article number
Rated continuous power
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, appox.
On-board computer
Article number
Max. charging current,
USB connection
Charging voltage,
USB connection
Operating temperature
Storage temperature
Charging temperature
Degree of protection
Weight, appox.
This device is in compliance with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device must not cause harmful interference, and
(2) this device must accept any interference that is received, in-
cluding interference that may cause undesired operation.
This device is in compliance with CAN ICES-3(B)/NM B-3(B).
Bosch eBike system uses FreeRTOS (see www.freertos.org)
Bike lights*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery pack in all country-specific ver-
sions, depending on the statutory regulations
Bosch eBike Systems
Drive Unit
0 275 007 029
W
Nm
V
°F
+23...+104
°F
+14...+122
IP 54 (dust and splash
water protected)
lb
Intuvia
1 270 020 906
mA
V
°F
+23...+104
°F
+14...+122
°F
+32...+104
IP 54 (dust and splash
water protected)
lb
V
W
W
Assembly
Inserting and removing the battery pack
To insert or remove the battery pack in/from the eBike,
250
please read and follow the battery pack operating instruc-
50
tions.
36
Inserting and removing the on-board computer
8.8
500
4
5
3 On-board computer
4 Holder for on-board computer
15 Lock latch for on-board computer
0.3
16 Locking screw for on-board computer
To insert the on-board computer 3, slide it from the front
into the holder 4.
To remove the on-board computer 3, press the lock latch
15 and slide the on-board computer toward the front out of
the holder 4.
Remove the on-board computer when you park the
eBike.
6
It is possible to secure the display unit against removal in
the holder. To do so, remove the holder 4 from the handle-
8.4
bar. Put the display unit in the holder. Screw the locking
0.6
screw 16 (thread M3, 8 mm long) from below into the
thread provided in the holder. Attach the holder back onto
the handlebar.
English–21
3
15
16
0 276 001 USAen | (17.6.15)
Advertisement
Table of Contents
