Table of Contents
Advertisement
When set to "Delay 4 Sec.", the ATX switch can be used as a normal system power-off button when pressed for less than 4
seconds. "Instant" disables the ATX switch function when the button is pressed under 4 seconds.
3.5.12 Resume by Ring ( for ATX power supply )
This option lets you specify enable or disable external Modem Wake Up function. The function of power on through modem
when system is off.
To select "Enabled" : To let the system to enter the environment of DOS or Windows 95/98 OS before system is power off. As
long as there are any massage through the Modem to enter the System during system is power off. The system will enable
power on function.
3.5.13 Resume by Alarm ( for ATX power supply )
Set this option to enable or disable the RTC Alarm to Wake Up the system which is set at soft Off.
3.5.14 Wake up on LAN ( for ATX power supply )
This allows you to remotely power up your system through your network by sending a wake-up frame or signal. With this
feature, you can remotely upload/download data to/from systems during off-peak hours. Set to Enabled to set this
feature.
3.5.15 Date (of Month) Alarm, Time (hh:mm:ss) Alarm
Set these options to specify the RTC Alarm time on Date / Hour / Minute / Second.
3.5.16 IRQ 8 Break Suspend
To enable or disable the detection of IRQ 8 (RTC) event for power down state transition.
3.5.17 IRQ[3-7, 9-15], NMI
To enable or disable the detection of IRQ 3-7, IRQ 9-15 or NMI interrupt events for power down state transition.
3.5.18 Primary/Secondary IDE 0/1, Floppy Disk, Serial & Parallel Port
These items enable or disable the detection of IDE, floppy, serial and parallel port activities for power down state transition.
Actually it detects the read/write to/from I/O port.
3.6 PNP/PCI Configuration Setup
3.6.1 PNP OS Installed
This field allows you to use a Plug-and-Play (PnP) operating system.
Please set it as " No " if the operating system has no PnP function or to avoid reassigning the IRQs by the operating
system.
3.6.2 Resources Controlled By
Default setting is "Auto". This setting allows the BIOS to self detect setting and Plug-and-Play devices during start up. The user
can select and configure IRQs under "Manual" mode.
Figure 3.6 PNP/PCI CONFIGURATION SETUP
ROM PCI / ISA BIOS (XXXXXXXX)
PNP/PCI CONFIGURATION
AWARD SOFTWARE, INC.
Advertisement
Table of Contents
