Table of Contents
Advertisement
English – 10
Charging the battery when inserted in the bicycle
(5)
(7)
(5)
(5) Charging connector
(6) Socket for charging connector
(7) Charging socket cover
(11) PowerPack
Switch the battery off. Clean the cover of the charg-
ing socket (7). Avoid getting dirt, e.g. sand or soil, in
the charging socket and contacts in particular. Lift the
cover of the charging socket (7) and plug the charg-
ing connector (5) into the charging socket (6).
There is a risk of fire due to the charger heating
u
up during charging. Ensure the battery on the
bike is completely dry and placed on a fireproof
surface before charging. If this is not possible, re-
move the battery from the holder and charge it in a
more suitable location. When doing so, read and
observe the operating instructions of the battery.
0 275 U07 3CX | (17.03.2022)
(7)
(6)
(6) (11)
Charging process
The charging process begins as soon as the charger is
connected to the battery or charging socket on the
bike and to the mains.
Note: The charging process is only possible when the
temperature of the eBike battery is within the permit-
ted charging temperature range.
Note: The drive unit is deactivated during the charg-
ing process.
The battery can be charged with or without the on-
board computer. When charging without the on-
board computer, the charging progress can be ob-
served via the battery charge indicator.
When the on-board computer is connected, a charg-
ing notification appears on the display.
The state of charge is displayed by the battery charge
indicator (8) on the battery and by the bars on the on-
board computer.
The LEDs on the battery charge indicator (8) will flash
during the charging process. Each solid illuminated
LED represents approximately 20 % of the charging
capacity. The flashing LED indicates the next 20 %
currently charging.
Once the eBike battery is fully charged, the LEDs ex-
tinguish immediately and the on-board computer is
switched off. The charging process is terminated. The
state of charge can be displayed for 5 seconds by
pressing the on/off button (9) on the eBike battery.
Disconnect the charger from the mains and the bat-
tery from the charger.
When the battery is disconnected from the charger,
the battery is automatically switched off.
Note: If you have charged the battery on the bike,
carefully close the charging socket (6) with the cover
(7) after charging, so that no dirt or water can get in.
If the charger is not disconnected from the battery af-
ter charging, the charger will switch itself back on af-
ter a few hours, check the state of charge of the bat-
tery and begin the charging process again if neces-
sary.
Bosch eBike Systems
- Quick Links:
- Using Your Operator's Manual
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
