Table of Contents
Advertisement
System Requirements
This section describes the power and environmental requirements for the
Antares ultrasound imaging system.
Power Supply Requirements
MAINS V
Range
230V~
196V to 264V
115V~
98V to 132V
100V~
90V-110V
Possible Combinations with Other
Equipment
Only the peripheral devices listed in the System Reference are approved for
use with the Antares ultrasound system. Any use of other devices with the
system will be at the user's risk and may void the system warranty.
On-board peripheral devices may need to be installed by an authorized
Siemens representative or approved third party. Check with your sales
representative.
WARNING: Accessory equipment connected to the analog and digital
interfaces must be certified according to the respective EN and IEC standards
(e.g., EN 60950 and IEC 60950 for data processing equipment and EN 60601-1
and IEC 60601-1 for medical equipment). Furthermore, all configurations shall
comply with the system standards EN 60601-1-1 and IEC 60601-1-1. Anyone
who connects additional equipment to the signal input or signal output port
configures a medical system and is therefore responsible that the system
complies with the requirements of the system standards EN 60601-1-1 and
IEC 60601-1-1. Siemens can only guarantee the performance and safety of the
devices listed in the Accessories and Options chapter. If in doubt, consult the
Siemens service department or your local Siemens representative.
[ 1 ]
I N S T R U C T I O N S
F O R
Max. Current
6.5 amps
12 amps
15 amps
U S E
6 T e c h n i c a l D e s c r i p t i o n
Frequency
Freq. Range
50/60 Hz
47 to 63 Hz
50/60 Hz
47 to 63 Hz
50/60 Hz
47 to 63 Hz
System Reference
Accessories and
Options
Ch 2
6 - 2 5
Advertisement
Chapters
Table of Contents
