Table of Contents
Advertisement
CHAPTER 13
LODGING/HEALTH CARE DATA
1. Lodging/Health
Care Features Data Block
(Table 13-l)
1 .Ol
The Lodging/Health
Care Features Data Block
(DHMF Program)
defines the number of miscella-
neous
parameters
that pertain
to the Lodging/
Health Care features.
Data is entered
as follows:
NOTE:
Be sure to run the DMYC program
(Back-up
Memory
Check
Entry Procedure)
when
the
system
is put into the Lodging/Health
Care
mode of operation,
and before this program
is
entered,
REQ (Request)-Indicates
that the program
has
loaded.
Three responses
are possible:
NEW-To
create a new Data Block.
CHGTo
alter an existing Data Block.
OUT-To
delete an existing Data Block.
NOTE:
If OUT is entered,
all entries
will be set to
"NONE. "
PROGRAMMING PROCEDURES
SECTION 200-255-313
FEBRUARY 1992
AWU SRC (Automatic
Wake-up Source)-
identifies
the source
that the called party will
hear after the wake-up
call has been answered.
Enter: MOH-Music-on-Hold.
VCE-Preprogrammed
digitized
voice
announcement.
NONE-Silence.
AWU POR (Automatic
Wake-up)-Identifies
the
output
port that the system
will use to send
automatic
wake-up
verification
information.
Enter:
SMDR, TTY, or NONE.
MW POR
(Message
Waiting)-Identifies
the out-
put port that the system will use to send message
waiting verification
information.
Enter:
SMDR, TTY, or NONE.
MR POR
(Message
Registration)-Identifies
the
output
port that the system
will use to send
message
registration
information.
Enter:
SMDR, TTY, or NONE.
RMS
(Room Status
Audit)-Identifies
the output
pot-tthat the system will use to send Room Status
Audit information.
Enter:
SMDR, -TTY, or NONE.
13-1
Advertisement
Chapters
Table of Contents
