Chapter 10
First-Time Setup
Figure 10-11
Positioning the Small and Large Targets for the Second Row
Large target
d.
Step 7
Remove the targets and place them in front of the left camera.
Step 8
Complete
Step 9
Remove the targets and place them in front of the right camera.
Step 10
Complete
Attaching the Camera Hood Assembly
After you complete the camera adjustment, attach the camera hood assembly. See
Attach the top hood before attaching the bottom hood.
Note
Caution
Do not overtighten the screws, or use a power screwdriver to tighten the screws. The recommended
torque for the screws is 0.8N.m (7 inch-pounds).
In addition, make sure that you use screws of the correct length (20 mm). Overtightening the screws, or
using a screw that is too long, can cause the plastic hoods to break.
OL-14521-01
10 ft
Make sure that the targets are still be aligned within the green and red boxes on the display. See
Figure 10-9
for more information.
Step 1
through
Step 6
Step 1
through
Step 6
Small target
for the left camera.
for the right camera.
Setting Up CTS Components
10 ft
Figure
10-12.
Cisco TelePresence System 3200
10-15