First-Time Setup
Revised: December 7, 2011, OL-14521-01
After you have assembled the Cisco TelePresence System (CTS), you set up the individual system
components (such as displays and cameras) using Hardware Setup, located under Troubleshooting in
the CTS Administration software. This chapter explains how to initially set up CTS components and
contains the following sections:
•
•
You cannot perform diagnostics during an active Cisco TelePresence system call.
Note
Parts List
Key
Part Description
Camera Hood Assembly
(Figure
1
Camera assembly
2
Camera hood cover: top
3
Camera hood cover: bottom
7
M4 x 12mm Pan Head screws, black
Loading CTS Administration Software
CTS Administration Software is factory-installed on each codec and loads during initial bootup.
To load CTS Administration Software:
Turn on the Auxiliary Control Unit.
Step 1
Power on the three PDUs in that are located on the accessory cabinets and the single PDU that is
Step 2
underneath the first row table (near the projector).
OL-14521-01
Loading CTS Administration Software, page 10-1
Setting Up CTS Components, page 10-4
Part Number
10-12)
800-30872-01
68-3277-01
48-2426-01
C H A P T E R
Qty
Ctn
Notes
1
2
1
2
1
2
2
N/A
Cisco TelePresence System 3200
10
10-1