2.3.2 Mounting
Remember that this inverter is heavy! Please be careful when lifting out from the package.
The inverter is suitable for mounting on concrete or other non-combustible surfaces only.
1
Please use the mounting bracket as a template to drill 4 holes in the correct positions
(10mm in diameter and 80mm in depth).
Use the expansion bolts in the accessory box and tightly attach the mounting bracket to the
wall.
Note: Bearing capacity of the wall must be higher than 30kg, otherwise it may not be able to
keep the inverter from dropping.
228.5mm 228.5mm
400mm
2
FOR AUSTRALIA ONLY. Lock the DC switch before mounting. Make sure that the DC switch is
locked unless the inverter is powered on.
3
Carry the inverter by holding the heat sink on two sides and place the inverter on the
mounting bracket.
wall bracket
117.5mm
104.5mm
self-tapping screws
8
expansion pipe