Panasonic LP-GS Series Operation Manual page 343
Laser marker navi smart
Hide thumbs
Also See for LP-GS Series:
- Serial communication command manual (208 pages) ,
- Setup & maintenance manual (190 pages) ,
- Quick reference (46 pages)
Table of Contents
Advertisement
E664
Cause:
Two or more external input functions which may not be combined are set
in one file. The following combinations are not allowed:
•
Character entry by SIN command/Register function (registered
characters switching via I/O connector)
•
Character entry by SIN command/Marking offset via I/O signal
•
Register function (registered characters switching via I/O
connector)/Marking offset by SEO command
•
Linking of image processing devices/Trigger mode "Continuous
trigger"
•
LP-RC, LP-RF, LP-RV:
Linking of image processing devices/TARGET DETECTION IN (X7)
input of TERMINAL connector
Remedy:
Delete any one of these functions from the file.
E665
Cause:
The marking data include characters that cannot be converted into 2D
code.
Remedy:
•
Use characters which can be converted into 2D code.
•
For QR Code, change the mode setting. For Data Matrix, change the
character type setting. For PDF417, change the compaction mode
setting.
E666
Cause:
•
The 2D code cannot be generated with the specified settings.
•
The number of characters exceeds the upper limit of the selected 2D
code.
Remedy:
Check the code settings and the number of characters.
E667
Cause:
The filling pattern specified for the 2D code is not available in the 2D
code font (font number: 2D).
Remedy:
•
Change the filling pattern.
•
Add the required font data in the "Data management" screen.
ME-NAVIS2-OP-1
27 Troubleshooting
343
- Quick Links:
- Product Models
Hide quick links:
Advertisement
Table of Contents
