Panasonic LP-GS Series Operation Manual page 328
Laser marker navi smart
Hide thumbs
Also See for LP-GS Series:
- Serial communication command manual (208 pages) ,
- Setup & maintenance manual (190 pages) ,
- Quick reference (46 pages)
Table of Contents
Advertisement
27 Troubleshooting
E404
Cause:
The "Stop laser" button in Laser Marker NAVI smart was selected.
Remedy:
Solve the safety problem. Then select "Reset" in the error dialog in Laser
Marker NAVI smart to finish the laser stop status.
E405
Cause:
The remote interlock input is open.
Remedy:
•
Connect the REMOTE INTERLOCK IN input on the TERMINAL
connector.
•
Check the status of the safeguards connected to the REMOTE
INTERLOCK IN input.
•
Check the operation logic of the connected device.
•
If you want to deactivate this alarm when the shutter is closed, set
"Deactivate while shutter closed" in "System settings" > "Operation/
information" > "INTERLOCK alarm detection".
•
Connect the internal or external power supply to IN COM. 1 (X2) and
OUT COM.1 (Y2) on the TERMINAL connector.
Applies to LP-RC, LP-RF, LP-RV only.
E410
Cause:
Laser pumping was turned off during the marking process.
Remedy:
•
Start the marking process after laser pumping has completed.
•
Check the operation logic of laser pumping and trigger input.
•
Check the connection of the external devices to the I/O terminals or
the communication port.
•
Make sure the switch or the sensor connected to TRIGGER IN (X5)
of the TERMINAL connector operates without chattering.
E411
Cause:
The marking trigger signal was entered while laser pumping was off.
Remedy:
•
Start the marking process after laser pumping has completed.
•
Check the operation logic of laser pumping and trigger input.
•
Check the connection of the external devices to the I/O terminals or
the communication port.
•
Make sure the switch or the sensor connected to TRIGGER IN (X5)
of the TERMINAL connector operates without chattering.
328
ME-NAVIS2-OP-1
- Quick Links:
- Product Models
Hide quick links:
Advertisement
Table of Contents
