Table of Contents
Advertisement
Phantom Function
This control unit has three phantom functions; global
phantom, local phantom, and destination offset local
phantom. The phantom functions have the following
features.
Global phantom
The global phantom allows you to switch up to 2,800
crosspoints by pressing a single button. This function
may be used to switch crosspoints defined for a
phantom name with two or more control units.
Note
The global phantom is set on the primary station, so
the route function does not work in combination with
it. To activate the route display function in
conjunction with the global phantom function, all
crosspoints to be switched must be set on the phantom.
Local phantom
The local phantom allows you to switch multiple
crosspoints by pressing a single button, or to switch
crosspoints independently from destinations controlled
on the unit. Up to 64 crosspoints can be set for a
phantom name.
Destination offset local phantom
The destination offset local phantom sets the
destination of the local phantom to a substitute
parameter such as "(DST + *)," where "*" is an offset
value of the connector number of the destination.
"DST" is automatically substituted with the connector
number of the destination selected when phantom-
switching. For example, if the destination is OUT005,
the connector number of the destination is 015, and the
offset value is 2 (* = 2), the destination 017 is
switched.
To execute the destination offset local phantom, first
select and check the destination.
Examples of this Phantom are given below.
Example 1
Assign a source (audio source AUD007 for example)
of a level to multiple sources of another level (video
source IN001 and IN005 for example)
Source name for
each level
Setting of destination
Source LEVEL LEVEL2 offset local phantom
name 1
IN001 IN001 AUD007 IN001: DST+0<IN001-
IN001: DST+0<AUD007- 01000000
IN005 IN005 AUD007 IN005: DST+0<IN005-
IN005: DST+0<AUD007- 01000000
Example 2
To set a pair of crosspoints (multiple audio channels,
video key signal for example)
Setting of Destination Offset Phantom
IN001: DST + 0<IN001-10000000
IN001: DST + 1<IN002-10000000
IN003: DST + 0<IN003-10000000
IN003: DST + 1<IN004-10000000
VTR Control
You can assign tape-transport functions (EJECT,
STOP, PLAY, REW, F FWD, REC) to source/
destination select buttons and controls a VTR from the
control panel.
BKS-R1617
ASSIGN
DEST
LOCK
PROT
(CHOP)
BKS-R1621
ASSIGN
DEST
LOCK
PROT
(CHOP)
SELECTOR
11 12
13
14 15 16
BKS-R1621
EJECT REC REW PLAY F FWD STOP
10000000
10000000
SELECTOR
11 12
13
14 15 16
BKS-R1617
EJECT REC REW PLAY F FWD STOP
BKS-R1618
9
Advertisement
Table of Contents
