Table of Contents
Advertisement
button is lit in green. In 4 DESTINATION mode,
dual function setting is enabled on buttons 1 to 4
only. Adding to source select function, destinations
for blocks 1 to 4 can be assigned to destination select
buttons 1 to 4.
For details on defining the button functions, refer to the
Installation Manual supplied with the routing switcher.
Source selection function (lit in green)
When you press a button, the signal fed to the switcher
(source) corresponding to the pressed button is
selected and is supplied to the output connector
(destination). If the phantom function has been set, the
sources set for the button are selected.
If prompt lamp-light mode has been set, the pressed
button lights in bright green to show the selected
source. If status display mode has been set, the system
checks that the selected crosspoint has been switched,
and the button lights in bright green.
For details, see page 16.
Note
When the PROT lamp is lit, source switching is
disabled.
Destination selection function (lit in amber)
When you press a button, the output connector of the
switcher (destination) corresponding to the pressed
button is selected. The pressed button lights in bright
amber to show the selected destination.
8 SELECTOR knob
When you turn the knob with the DEST lamp not lit,
source names appear in sequence in the preset display
window. When the DEST lamp is lit, a destination
name appears.
While you turn the knob with the ASSIGN button held
down, the type name appears in sequence in the preset
display window. When you release the ;ASSIGN
button and turn the SELECTOR knob, only the source
or destination names using the selected type name
appear in the preset display window in sequence. You
may limit the available names on the control terminal
as shown below.
• A source e to which secret has been set is skipped.
• Sources and destinations can be limited using the
available source/destination table.
9 ~AC IN (AC power input) connector
Connect to an AC power source using the designated
AC power cord.
0 U (ground) connector
For signal grounding
qa REMOTE 1 connector (BNC connector)
Connect to the S-BUS line using the T bridge
(supplied) and 75-ohm coaxial cable (BELDEN 8281
or equivalent).
qs RS-232C connector (D-sub 9-pin)
For servicing. Connect to a computer for downloading
software or monitoring communication status.
qd REMOTE 2 connector (D-sub 9-pin)
To connect an RS-422 communication line
13
Advertisement
Table of Contents
