Table of Contents
Advertisement
Changing a channel of Wireless
TX and Wireless RX
If there is a similar wireless product nearby,
interference may occur. In this case, change to
another channel using
ID/CHANNEL (ID./CH.) button of Wireless TX.
Manual setting
Press ID/CHANNEL (ID./CH.) button for less
than about 3 seconds.
If the wireless TX and wireless RX signals do not
match after operating as above, operate it again about
three times.
Auto setting
1 Disconnect the DC power cable from the
Wireless TX.
2 Connect the DC power cable Wireless TX while
you pressing the ID/CHANNEL (ID.CH.) button
of Wiress TX.
- The blue LED indicator
will flicker
3 Disconnect the DC power cable from the
Wireless TX and release the ID/CHANNEL
(ID.CH.) button of Wiress TX.
4 Connect the DC power cable Wireless TX.
- The ID setting becomes optimization automaticly .
Note:
The wireless speakers may not receive the changed channel
of transmitter (The LED of Wireless TX will turn blue. The The
LED of Wireless RX will turn red). In this case set the ID as
next paragraph.
Rear speaker (wireless speakers) is no sound.
The DC power cable is not connected the Wireless TX and main unit.
Connect the Wireless TX and main unit with the DC power cable.
Power cord of wireless RX (or wireless speakers) is not connected.
Connect the Power cord of wireless RX (or wireless speakers).
Sound is cut off.
Change a channel of Wireless TX. (Follow steps "Changing a channel of Wireless TX
and Wireless RX")
If rear speaker (wireless speakers) is no sound after operating as above, disconnect
and connect the power cord of Wireless RX (or wireless speakers) or set up an ID of
wireless TX and wireless RX (or wireless speakers).
Setting an ID of Wireless TX and
Wireless RX
When the unit is manufactured, the ID is already set.
If an interference occurs or you use a new Wireless
RX, an ID is set again.
1. Set the wireless TX and wireless RX within 50cm of
eachother.
2. Turn the Wireless TX and Wireless RX on.
3. Press the ID/CHNNEL (ID./CH.) button of Wireless
TX and ID button of Wireless RX at the same time
for more than about 3 seconds.
- The wireless RX and Wireless RX of blue LED
indicator
4. Release the ID/CHNNEL (ID./CH.) button of
Wireless TX and ID button of Wireless RX.
- ID is set up.
Notes:
.
If there is a product with a strong electromagnetic field
nearby, interference may occur.
Do not operate a portable transmitter (such as a wireless
network device) near this product.
CAUTION
will flicker
.
11
Hide quick links:
Advertisement
Table of Contents
