Table of Contents
Advertisement
Control function operation
Boat control functions
Engine shut-off switch
WARNING
Always attach the engine shut-off cord
(lanyard) to your PFD before starting the
engine. Failure to attach the cord could
result in a runaway boat if the operator is
ejected.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
in such a way that it could become en-
tangled, preventing it from functioning.
Avoid accidentally pulling the cord dur-
ing normal operation. Once the engine
has stopped, you have no steering con-
trol of the boat which could result in an
accident. Also, without engine power,
the boat could slow rapidly from planing
speed. This could cause people and ob-
jects in the boat to be thrown forward,
which could cause injury.
The clip on the end of the engine shut-off
cord (lanyard) must be attached to the engine
shut-off switch for the engine to run. The cord
must be attached to a secure place on the
operator's PFD. Should the operator fall over-
board or leave the helm, the cord will pull out
the clip, stopping the ignition to the engine.
This will prevent the boat from running away
under power.
36
1
1
Clip
2
Engine shut-off switch
3
Engine shut-off cord (lanyard)
Battery switch
The battery switch is located in the rear un-
derseat storage compartment (port).
1
Battery switch
Turn the battery switch to the OFF (red) posi-
tion when the boat will not be used again right
away. Turning the switch to the OFF (red) po-
sition will prevent the battery from being
drained if another electrical switch is acci-
dentally left in the on position. NOTICE: Do
not turn the battery switch to the OFF (red)
position if the boat is moored in the water
as it will prevent the anchor light from
functioning.
2
3
1
Advertisement
Table of Contents
