(7) While pulling the main pole down, push
the snap button and shorten each rear
support pole to either the middle position
for cruising or to the short position if you
are using the wakeboard tower. Be sure
the snap buttons click into place.
1
2
3
4
1 Rear support pole
2 Short position
3 Middle position
4 Snap button
NOTICE
Do not exceed 72 km/h (45 mph) with the
bimini top in the up position.
Be careful not to push the snap button
and extend the pole too far. Otherwise,
the lower section of the pole could fall
into the water.
Storing the bimini top
To store the bimini top:
When storing the bimini top, simply reverse
the steps for setting it up.
Trailering with the bimini top
The bimini top must be secured to the boat
when it is being trailered. When the boat is
trailered with a genuine Yamaha boat cover,
simply store the bimini top in the fully col-
lapsed position and install the storage cover.
Equipment operation
If a boat cover is not used, wrap an elastic
cord around the top and secure the ends to
the tow pylon on the wakeboard tower to re-
strict movement.
Removing the bimini top
To remove the bimini top:
(1) Store the bimini top. See "Storing the bi-
mini top".
(2) While supporting the bimini top, remove
the lock pins securing the main pole to
the wakeboard tower, and then remove
the top.
1
2
1
Bimini top
2
Lock pin
Installing the bimini top
To install the bimini top:
When installing the bimini top, simply reverse
the removal steps, and then make sure that
the lock pins are securely installed.
95