Table of Contents
Advertisement
1.3.2. Power and air supplies
Power and air supplies required to operate the machine properly are as follows:
Power
supply
Air supply
Note
Basically use one hose from the air source to the machine dedicatedly without branching the hose.
Otherwise required airflow amount per machine may not be obtained. Also use air hoses of at least
8mm inner diameter for the same reason. Even if the air pressure at machine idling is normal,
when the machine runs consuming large amount of air, the air pressure can drop abruptly.
Note
The following instructions are described in the machine delivery spec sheets:
Power supply: Customers are requested to prepare power cables and power the machine.
Air supply: Customers are requested to prepare a 30SH socket air hose.
Single-phase 200/208/220/230VAC +/- 20 (6.9KVA)
Wire lead sectional area: 6.0mm
110 L/minute ANR
220 L/minute ANR (in use of the vacuum backup option)
Supply pressure 0.45 MPa or higher
Note: ANR (Atmosphere Normal de Reference) is quantity of air at conditions
20 degree Celsius, 101.3 KPa absolute pressure, and 65% relative humidity.
101.3 KPa absolute pressure is atmospheric pressure. This differs from
discharge airflow used in a compressor spec sheet, etc.
or larger (AWG#10 equivalent or higher)
2
SI1906002E-000=YSP10 installation and adjustment procedures
10/120
For Service Engineers
Service Information
Hide quick links:
Advertisement
Table of Contents
