Installing the analyzer modules and option module
5.5 Cabling
5.5
Cabling
There is a cable kit for each analyzer module. The CAN cable (12-pin ribbon cable) which
connects all components always has all connections.
The supply and flat ribbon cables are laid separate from each other in the housing and
fastened with cable ties to the embossings intended for that purpose. The power supply
cables
housing.
①
Figure 5-6
Cable damage
Make sure that the cables are carefully laid and secured again after you exchange an
analyzer module or other component. Route the cables close to the housing wall. Cables
could otherwise be damaged by friction or other mechanical influences.
Note
Cable ties
Use only the high-temperature cable ties listed in the spare parts list, see Spare parts list for
rack-mounted housing (Page 73).
34
②
are located at the bottom, the ribbon cables
Ribbon cable
Cabling example
CAUTION
①
approximately in the center of the
②
Power supply cable
Operating Instructions, 01/2013, A5E31874006-01
Rack-mounted device