Table of Contents
Advertisement
1-10. Installation Procedure
4. Loosen the four screws (RK5 x 35), and remove the four washers for transportation.
n
Store the removed washers for transportation.
5. Pull out the processor assembly (5 cm).
6. Remove the connector CN3 (rear) of the processor assembly from the rear of the unit.
7. Pull out the processor assembly to the position hooking the stopper.
8. Install the handles provided with the unit using the two screws respectively (RK5 x 12).
9. Push in the processor assembly completely.
n
Firmly push in the two power connectors of the processor assembly to the connectors of the unit until
they connect.
10. Connect the connector CN3 (rear) of the processor assembly from the rear of the unit.
11. Secure the processor assembly with the four screws and trapezoid washer.
RK5 x 12
Trapezoid washer
RK5 x 14
Handle
Handle
1-18
Washer
Processor assembly
Trapezoid washer
RK5 x 14
Flat cable
CN3
Stopper
Washer
RK5 x 12
FVS-1000 MMP1
Advertisement
Table of Contents
