Page 13
English For the customers in Europe WARNING This product with the CE marking complies with both the To prevent fire or shock hazard, do not expose the unit to EMC Directive (89/336/EEC) and the Low Voltage Directive rain or moisture. (73/23/EEC) issued by the Commission of the European Community.
Page 14
WARNING This unit has no power switch. When installing the unit, incorporate a readily accessible disconnect device in the fixed wiring, or connect the power cord to a socket-outlet which must be provided near the unit and easily accessible. If a fault should occur during operation of the unit, operate the disconnect device to switch the power supply off, or disconnect the power cord.
Rear Panel(BKDS-7080 and BKDS-7081) ........8(E) Example Configuration ............... 9(E) Specifications ..................10(E) Overview The BKDS-7080/7081 is a remote control panel that can be connected to Sony digital video switchers to enable selection of AUX bus signals by remote control. Supported Switchers The BKDS-7080/7081 can be used with the following digital video switchers.
AUX or EDIT PVW buses. • The BKDS-7080 is configured at the time of installation to control specified buses. • The BKDS-7081 allows selection of control buses by delegation buttons on the front panel.
Names and Functions of Parts Front Panel BKDS-7080 front panel 1 to 8 are the same on the BKDS-7080 and BKDS- 7081. 1 On air tally indicator 8 KEY button 2 Cross-point selection buttons 7 PGM button 6 M/E3 button...
Page 18
Names and Functions of Parts 1 On air tally indicator 6 M/E3 button This indicator lights or flashes in red or green to In a 3M/E or 3.5M/E system, this button selects the indicate the following states. video created with the M/E-3 bank. Lit in red: Signals on the bus controlled by this unit In a 1.5M/E or 2.5M/E system, it selects the PGM/PST are part of the switcher’s program output.
Page 19
Correspondence between delegation buttons and buses Correspondences in a standard system and in an I/O expansion system (1) (In an I/O expansion system, buttons corresponding to M/E2 UTILITY and M/E3 UTILITY are disabled.) M/E-1 KEY1 M/E-1 KEY2 EDIT PVW M/E-2 KEY1 M/E-2 KEY2 M/E-3 KEY1 M/E-3 KEY2...
Names and Functions of Parts Rear Panel (BKDS-7080 and BKDS-7081) The size of the rear panels differ on the BKDS-7080 and BKDS-7081, but the names and functions of the connectors are the same. AC IN REMOTE2 REMOTE1 2 REMOTE1 connector...
Example Configuration When connecting this unit to a DVS-7000 series digital video switcher, cascading connections as shown below can be made from a single switcher port. Port 1 Port 7 Rear panel of DVS-7000A Digital Video Switcher • The DVS-7000/7000A/7200/7200A allow up to 28 Up to 4 control panels per port control panels to be connected to the following 7 ports: DME1 to DME4, REMOTE1 to REMOTE3.
(storage:–20°C to +60°C (–4°F to +140°F)) Humidity 10% to 90% RH Dimensions (w/h/d, excluding projections) BKDS-7080: 482 × 44 × 120 mm (19 × 1 × 4 inches) BKDS-7081: 482 × 88 × 120 mm (19 × 3 × 4...
Page 23
The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any...