Table of Contents
Advertisement
RESU
Drill
Temp
10H
Prime
late
Standing bracket 1
Standing bracket_1
Battery Module B
n t
R e a
F r o
r
Label
Wall
Battery Module Direction
R e a
r
n t
F r o
Battery Module A
F r o
n t
Spacer
n t
F r o
(used for assmbly ang disassembly)
Label
Wall
Battery Module B
Rear
Front
Battery Module A
F r o
F r o
TOP VIEW
n t
n t
F r o
n t
F r o
n t
Module Support BRKT
3. Remove the Drill template and fi x the
Standing bracket 1 on the wall.
4. Place Battery Module B on the rear
side of Module Connect plate.
* The side without bolts is the front
of the Battery Module.
* Check the label to confi rm the
battery pack is of B. Label is
attached on the left side of Battery
Module.
5. Place Battery Module A on the front
side of Module Connect plate. The
Rear side of each Battery Module
should face each other. After that,
remove the Spacer between the wall
and Battery Module.
* Check the label to confi rm the
TOP
Battery pack is of A. Label is
attached on the left side of Battery
Module.
Battery Control Unit
F r o
n t
6. Assemble Module Support BRKTs
using 6 bolts each.
* Tighten the M6 Flange Bolts (x12)
with a torque of 5N·m.
7. Remove bubble wrap from
Battery Control Unit
Battery Modules
8. Place the spacers on the position
Spacer
TOP
Spacer
(used for assmbly ang disassembly)
Spacer
TOP VIEW
9. Place the Battery Control Unit on
Battery Control Unit
Battery Control Unit
* Be careful not to break the
connectors of Battery Control Unit
and the warning label of Battery
Modules.
marked with label on Battery
Modules.
top of the spacers, and align with the
Battery Module.
connector between the spacers and
the Battery Control Unit.
8
Advertisement
Table of Contents
