Offset
Name
address
Pulser operation
039H
ratio numerator
Pulser operation
03AH
ratio
denominator
Pulse operation
03BH
method
03CH
-
03DH
-
03EH
-
03FH
-
040H
-
J point control
041H
code
J point
042H
acceleration
time
J point
043H
deceleration
time
044H
J point target
045H
speed
046H
-
047H
-
17-36
Descriptions
Sets the multiplier for the input pulse string in the pulser operation.
(Number of command pulses) = (Pulse strings of input from pulser) x (Numerator of
ratio of pulser operation) / (Denominator of ratio of pulser operation).
Sets the divisor for the input pulse string in the pulser operation.
(Number of command pulses) = (Pulse strings of input from pulser) x (Denominator
of ratio of pulser operation) / (Numerator of ratio of pulser operation).
Set the single or interpolation operation pattern for the positioning operation.
-
-
-
-
-
Set the control code of the J point control.
Set the acceleration/deceleration time of the J point control.
Set the target speed of the J point control.
-
-
Default
Setting
Unit
value
range