How Can I Set And Add The Smoke Sensor (Connected To The Ai/Di Port On The Skylight Actuator) - Huawei SmartDC V100R021C10 User Manual
Data center controller
Hide thumbs
Also See for SmartDC V100R021C10:
- User manual (346 pages) ,
- Quick manual (12 pages) ,
- User manual (287 pages)
Table of Contents
Advertisement
ECC800 Data Center Controller
User Manual
Table 8-23 Function check
Check Method
Simulate a
smoky
environment
under the smoke
sensor.
----End
8.7.28 How Can I Set and Add the Smoke Sensor (Connected
to the AI/DI Port on the Skylight Actuator)?
If a smoke sensor is installed, perform the following steps to configure it.
Prerequisites
The smoke sensor has been connected to the AI/DI port on the skylight actuator
using a network cable.
To connect the cable for the smoke sensor, perform the following steps:
Short-circuit core wires 1 and 8 on the other end of the network cable, and
connect the network cable to the cable delivered with the smoke sensor. The
following table describes the cable connection.
Table 8-24 Smoke sensor cable connection
Wire of the Network Cable
Core wire 1 (orange-white), core wire
8 (brown)
Core wire 3 (green-white)
Core wire 6 (green)
Core wire 7 (brown-white)
None (reserved; no connection needed
and to be insulated)
Context
●
Issue 04 (2021-10-09)
Normal Connection Status
Smoke DI alarm is displayed
on the active alarm page of
the app or WebUI.
If the sensor is prefabricated, only check its settings.
Copyright © Huawei Technologies Co., Ltd.
Alarm Clearance Method
● If Smoke sensor type is
Smoke Sensor, power off
and reset the smoke
sensor to clear the alarm.
● If Smoke sensor type is
set to Smoke
Sensor(NC), press the
reset button of the smoke
sensor to clear the alarm.
Smoke Sensor Cable
GND (black)
+12 V (red)
Normally closed end (yellow)
Common end (green)
Normally open end (blue)
8 FAQ
338
- Quick Links:
- About this Document
Hide quick links:
Advertisement
Table of Contents
