Toro 31598 Operator's Manual page 16
Hide thumbs
Also See for 31598:
- Operator's manual (84 pages) ,
- Quick start manual (3 pages) ,
- Operator's manual (68 pages)
Table of Contents
Advertisement
Figure 3
1. Winglet
2. Hinge pin
3. Stop bolt
4. Install the front and rear stop bolts through the upper
mounting holes and eccentrics.
Note: Make sure the stop bolt engages the tab on the
hinge pin.
5. Install the nuts securing the stop bolts but do not
tighten at this time.
6. Repeat the procedure on left winglet.
4. Eccentric
5. Upper hole
6. Deck mounts
1. Winglet
2. Hinge pin
3. Bolt
7. Install the winglet belts as follows:
•
Start the belt around the winglet spindle pulley and
the front deck spindle pulley
•
Using a ratchet wrench or similar tool, move the
idler pulley away from the pulleys
•
Route the belt around the winglet spindle pulley
and the upper spindle pulley on the front deck.
•
Release the idler pulley to put tension on the belt.
1. Winglet spindle pulley
2. Front deck spindle pulley
8. Install the winglet deck cover and secure with rubber
latch
(Figure
6).
16
Figure 4
4. Eccentric
5. Lower hole
(Figure
5).
(Figure
Figure 5
3. Idler pulley assembly
5).
Advertisement
Table of Contents
