Advertisement
THERMA V
Split Type
2. Specifications
Technical Specifications
Indoor Unit Model Name
For Fan Coil Unit
Cooling
Operation
(Min.~Max.)
For under floor
Range
Heating
For Fan Coil Unit /Radiator
(Leaving
(Min.~Max.)
For under floor
Water)
Domestic Hot Water (Min.~Max.)
Operation Range (Ambient)
Type
Material
Water Volume
Internal Thermal Protect limit
DHW Tank
Maximum water temperature
Maximum water pressure limit
Material
Insulation
Thickness
Heat loss (for 24hr)
Water Volume
Buffer Tank
Material
Insulation Material
Type
Model
Motor type
Steps of Speed
Water Pump
Power input
Water Flow Rate
Pressure drop
Type
Quantity
Heat
Exchanger
Water Volume
(Water Side)
Water Flow Rate (Min. ~ Max.)
Insulation Material
Safety Valve
Pressure Limit
Devices for Water Circuit
Gas (Outer Dia.)
Refrigerant
Circuit
Liquid (Outer Dia.)
Water
Inlet (Inner Dia.)
Piping
Circuit
Outlet (Inner Dia.)
Connections
Cold Inlet (Outer Dia.)
DHW Tank
Water
Hot Outlet (Outer Dia.)
Circuit
Recirculation (Outer Dia.)
Sound Pressure Level
Sound Power Level
Unit
Dimensions (W × H × D)
Shipping
Unit
Weight
(without water)
Shipping
Note
1. Due to our policy of innovation some specifications may be changed without notification.
2. Wiring cable size must comply with the applicable local and national code. And "Electric characteristics" chapter should be considered for electrical
work and design. Especially the power cable and circuit breaker should be selected in accordance with that.
3. Sound Level Values are measured at Noise Measuring chamber accordance with standard. Therefore, these values depend on the ambient conditions
and values are normally higher in actual operation.
4. Capacities are net capacities and based on the following conditions. Refer to the Outdoor Unit Specifications for calculating the real capacity.
• Cooling : Indoor Water Temp. 23°C / 18°C, Outdoor Ambient Temp. 35°CDB / 24°CWB
• Heating : Indoor Water Temp. 30°C / 35°C, Outdoor Ambient Temp. 7°CDB / 6°CWB
• Interconnected Pipe is standard length and difference of Elevation (Outdoor ~ Indoor Unit) is Zero.
5. Sound pressure levels at a distance of 1m.
6. This is true for pipe connections of suitable dimensions and joint distance of up to 20m.
Pipe dimensions and types of pumps must always be verified or determined by the designing engineer of electrical installations.
Circulation pumps must be dimensioned in such a way so as to ensure rated voltage (see table) through the device.
°C
°C
°C
°C
°C
°C
-
Rated
°C
°C
bar
-
mm
kWh
Rated
-
-
-
-
-
EA
W
Min.
/ min
Rated
/ min
Max.
kPa
-
-
/ min
-
Max.
bar
-
-
-
-
mm(inch)
mm(inch)
mm(inch)
mm(inch)
mm(inch)
mm(inch)
mm(inch)
dB(A)
dB(A)
mm
mm
kg
kg
DHW Tank Integrated Unit
AHNW16606B0 [HN1616T NB0]
7 ~ 25
7 ~ 25
25 ~ 58
25 ~ 58
10 ~ 60
5 ~ 35
Hydro module with integrated boiler
Enameled steel
200
95
52
10
Polyurethane foam
50
1.67
40
Steel powder coated
Closed cell foamed rubber
Canned type for hot water circulation
Yonos PARA RS25/7 PWM1
BLDC
Variable speed 13% to 100%
3 ~ 45
16.0
46.0
70
Brazed Plate HEX
1
3.3
13 ~ 70
Closed cell foamed rubber
3
Manometer
Drain Valve / Fill Valve
Shut Off Valve
Air Vent
Ø 15.88 (5/8)
Ø 9.52 (3/8)
Male PT 25 (1)
Male PT 25 (1)
Male PT 19.05 (3/4)
Male PT 25 (1)
Male PT 19.05 (3/4)
27
36
607 × 2,079 × 725
640 × 2,195 × 790
228
238
3
Advertisement
