Nokia 7210 Configuration Manual page 432
Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs
Also See for 7210:
- User manual (185 pages) ,
- Service manual (19 pages) ,
- Schematics (11 pages)
Table of Contents
Advertisement
System Management
shutdown
Syntax
[no] shutdown
Context
configure>system>ptp>peer
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), and 7210 SAS-T (network and access-uplink)
Description
This command disables or enables a specific PTP peer. Shutting down a peer sends cancel
unicast negotiation messages on any established unicast sessions. When the peer is shut
down, all received packets from the peer are ignored.
If the clock-type is ordinary slave or boundary, and PTP is not shut down, the last enabled
peer cannot be shut down. This prevents the user from having PTP enabled without any peer
configured and enabled.
Default
no shutdown
port
Syntax
port port-id [create]
no port port-id
Context
config>system>ptp
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), and 7210 SAS-T (network and access-uplink)
Description
This command configures PTP over Ethernet on the physical port. The PTP process
transmits and receives PTP messages through the port using Ethernet encapsulation (as
opposed to UDP/IPv4 encapsulation).
The frames are transmitted with no VLAN tags even if the port is configured for dot1q or qinq
modes for encap-type. In addition, the received frames from the external PTP clock must
also be untagged.
There are two reserved multicast addresses allocated for PTP messages, as defined in IEEE
1588-2008 Annex F (see the
configured for the PTP messages sent through this port.
This command applies only if the PTP profile is set to g8275dot1-2014.
Changing the encapsulation or the port type of the Ethernet port is not permitted when PTP
Ethernet multicast operation is configured on the port. To change the encapsulation or port
type, the physical port must be shut down.
The no form of this command deletes the specified PTP port.
432
address
command for more information). Either address can be
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 17358 AAAB TQZZA
Hide quick links:
Advertisement
Chapters
Table of Contents
