Nokia 7210 Configuration Manual page 399
Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs
Also See for 7210:
- User manual (185 pages) ,
- Service manual (19 pages) ,
- Schematics (11 pages)
Table of Contents
Advertisement
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Parameters
coordinates — Specifies the coordinates describing the device location character string.
ip
Syntax
ip
Context
config>system
Platforms
7210 SAS-Mxp
Description
Commands in this context configure system-wide IP router parameters.
allow-cpu-fragmentation
Syntax
[no] allow-cpu-fragmentation
Context
config>system>ip
Platforms
7210 SAS-Mxp
Description
This command enables CPU-based IP fragmentation. When allow-cpu-fragmentation is
enabled, the CPM extracts oversized IPv4 packets from the datapath, fragments them using
the system CPU, and inserts the fragmented packets back into the datapath. Refer to the
7210 SAS-M, T, R6, R12, Mxp, Sx, S Router Configuration Guide for more information about
IP fragmentation.
The no form of this command disables CPU-based IP fragmentation.
Default
no allow-cpu-fragmentation
lacp-system-priority
Syntax
lacp-system-priority lacp-system-priority
no lacp-system-priority
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
3HE 17358 AAAB TQZZA
The string may be up to 80 characters. Any printable, seven-bit ASCII characters can
be used within the string. If the string contains special characters (#, $, spaces, and
so on), the entire string must be enclosed within double quotes. If the coordinates are
subsequently used by an algorithm that locates the exact position of this node then
the string must match the requirements of the algorithm.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
399
Hide quick links:
Advertisement
Chapters
Table of Contents
