Hitachi CP-WU5500 User Manual page 20
Hide thumbs
Also See for CP-WU5500:
- User's manual and operating manual (125 pages) ,
- User manual (124 pages) ,
- User manual (24 pages)
Table of Contents
Advertisement
STACK menu settings
3.3 Selecting lamp operation mode
NOTE • When DUAL is selected for LAMP MODE, the images projected from
the Main and Sub projectors may be different. It is recommended to set the
projectors as follows.
- Set the same image for TEMPLATE and START UP on the Main and Sub
projectors.
- Capture the same image for MyScreen on the Main and Sub projectors.
- Save the same image on MY IMAGE on the Main and Sub projectors.
- Set the same message content for the Messenger function
→
Messenger
• When DUAL is selected for LAMP MODE, image shift can result in image
quality degradation on the screen. Perform the INSTALLATION setting before
adjusting the image position as the image position will change when the
INSTALLATION setting is changed.
• When ALTERNATE is selected and an error occur on the projector in operation
causing the lamp to turn off, the other projector will automatically start to operate.
However, if the RS-232C cable is disconnected or AC power is not supplied, the
other projector will not turn on.
• In cases when PIN LOCK or TRANSITION DETECTOR on both projectors
is set to ON
(Operating Guide
not turn on even if ALTERNATE is selected. Enter the security code on both
projectors and one of the projectors will turn on.
• When Intellectual Stack is in use, the POWER indicator on the projector
operates differently from normal.
When both the Main and Sub projectors are in standby mode, the Main projector
determines which projector to turn on according to the STACK MODE setting
if the STANDBY/ON button on the remote control or control panel of the Main
projector is pressed.
- The POWER indicator on the Main projector blinks in green while the Main
projector determines which projector to turn on.
- If the Main projector is turned on, the POWER indicator on the Main projector
turns to steady green after lighting up, as per normal.
- If the Sub projector is turned on, the POWER indicator on the Main projector
lights in orange after the Sub projector is turned on.
- If an error occurs on the Main projector, the Sub projector turns on and the
POWER indicator on the Main projector lights or blinks in red.
20
(continued)
Function) on the Main and Sub projectors.
(Operating Guide
→
SECURITY
menu), the two projectors will
(Operating Guide
(Network Guide
→
SETUP
menu)
→ Troubleshooting)
Advertisement
Table of Contents
