Communication Services And Used Port Numbers - Siemens SINUMERIK 840D sl Equipment Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
②
Omitted when connecting via an MCP or MPP
③
Cable included in scope of supply
Figure 7-1
Options of connecting an NCU
Interface overview
Table 7-1
Interface
DRIVE-CLiQ
Ethernet IE1/OP
Ethernet IE2/NET
Ethernet (service socket)
PROFINET
Digital inputs/outputs
24 V power supply
USB
PROFIBUS DP1
PROFIBUS DP2/MPI
RS232 (service socket)
Measuring sockets (T0, T1, T2, and
M)
CompactFlash Card
Dual fan/battery module
7.2
Communication services and used port numbers
SINUMERIK supports the protocols listed in the following tables. The address parameters, the
relevant communication layer as well as the communication role and the communication
direction are specified for each protocol.
This information allows you to match the security measures for the protection of the automation
system to the used protocols (e.g. firewall).
The following table shows a section of the various layers and protocols that are used.
NCU 7x0.3B PN
Equipment Manual, 10/2020, 6FC5397-1EP40-6BA1
Overview of the interfaces that can be used
Designation
X100 - X105
X120
X130
X127
X150; ports 1, 2
X122, X132, X142
X124
X125, X135
X126
X136
X140
X141, X143
X109
X190
7.2 Communication services and used port numbers
Connector type
Spec. RJ45 socket
Standard RJ45 socket
Standard RJ45 socket
Standard RJ45 socket
Standard RJ45 socket
Screw terminals, 3x14 pin
Screw terminals, 4-pin
USB socket
9-pin SUB-D socket
9-pin SUB-D socket
9-pin SUB D plug connector
Sockets on the printed-circuit board
50-pin socket
6-pin
Connecting
47
Advertisement
Table of Contents
