GE LOGIQ E9 Service Manual page 648

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Assembling or replacing the Roll Stand (cont'd)

3.) Slide the cord loop hook, basket and handle into the rear channel in the order shown.

4.) Using the hex wrenches provided, tighten all of the set screws in each accessory to secure the po-

sition in the track.

a.) Tighten the top four set screws with the 3/32 inch hex wrench.

b.) Tighten the center four set screws with the 1/8 inch hex wrench.

c.) Tighten the bottom two set screws with 3/32 inch hex wrench.

Section 8-12 - V Nav Roll Stand and/or On-Board Stand Installation and/or Replacement

Figure 8-73 Post Assembly