Table of Contents
Advertisement
5 Calibration
5.2 Calibration points
5.2 Calibration points
Calibration point, with calibration index system
The calibration index system was installed on one side of the carriage. And there
is a corresponding calibration hole on the base body side. The calibration point is
reached when the two calibration holes align exactly with each other. A Ø8 x 50
pin should be used to do the fine calibration.
xx1800002148
A
B
C
D
E
xx1800002149
84
Calibration mark on the side plate of the base.
Calibration index system
Calibration hole on the index system.
NOTE: To make the calibration hole on the base body visible, here the calibration
index system is shown in semi-transparent.
Calibration pin
Calibration hole on base
Note
As FlexPLP IRPLP 220 with calibration index system has flexible installation
methods for both parts and axes combination, there are only one calibration
index system for each axis.
Here are the location of the calibration holes on the index system of FlexPLP
IRPLP 220.
© Copyright 2016 - 2018 ABB. All rights reserved.
Product manual - FlexPLP IRPLP 220
3HAW050041018-001 Revision: C
Advertisement
Table of Contents
