Table of Contents
Advertisement
16. Remove the four M-F studs.
17. Disconnect the harness and fl exible fl at cable from the connector (CN4 and CN5) on the VPR-103
board, then remove the VPR-103 board and LCD back sheet.
18. Remove the four screws, then remove the LCD mask, LED guide, LCD module and LCD back sheet
from the LCD holder.
M-F studs
CN4
CN5
Harness
VPR-103 board
19. Install the new LCD module.
Precaution for installation
When installing the new LCD module, be careful not to attach dust or fi ngerprint on the display area
of the LCD module.
20. Perform the setting of the switches S1 and S2 of the PR-312 board. (Refer to Section 1-8-1.)
21. Install the removed parts by reversing the steps 1 to 19 of removal.
Precaution for installation
. Be sure to insert the connectors to the circuit board securely for sure connection of the connectors.
. Apply the tapes (13 x 50) to the portion as shown in the fi gure.
Align the tape on the edge of
the RE-257 board.
RE-257 board
Tape (13x50)
1-10 (E)
Flexible flat cable
LCD back sheet
LCD holder
LCD back sheet
P2 x 2
LCD mask
LED guide
LCD module
Align the tape on the edge of the
connector (CN7) on the PR-314
board.
PR-312 board
CN7
Tape (13x50)
HDVF-C30WR
Advertisement
Table of Contents
