Table of Contents
Advertisement
6 Turn on the power to the logic analysis system and then the
See Also
1 Remove power from the target system.
2 Plug one end of the 50-pin cable into the emulation probe/
3 Plug the other end of the 50-pin cable into the connector on the
target system.
For information on designing a target system for use with the
emulation module, see "Designing the Target System for an Emulation
Probe/Module" on page 64.
To connect to the analysis probe
module.
analysis probe.
Chapter 3: Connecting to a Target System
Making the Target System Connection
71
Advertisement
Table of Contents
