Table of Contents
Advertisement
16
MC012C-AS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Axle Shaft, Bearing, and Oil Seal Installation, Continued:
84
82
80
81
5.6. Install the rubber boot (26) onto the large washer (23). See following NOTE.
NOTE: Push the rubber boot onto the washer so that the washer edge fits into the boot-lip groove.
5.7. Install the brake drum and wheel.
6. Repeat steps 2 through 5 for the remaining rear axle if necessary.
UNITIZED TRANSAXLE REMOVAL
See General Warning, Section 1, Page 1-1.
∆
WARNING
• To perform this procedure, the hydraulic system must be opened. As a result, the brakes must
be bled after the correct reinstallation of the brake components. Failure to bleed the brakes
could result in decreased braking performance due to air being trapped in the hydraulic
system. Use only DOT 5 brake fluid. See Bleeding the Hydraulic Brake System, Section 6,
Page 6-31.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle is in NEUTRAL. Chock
the front wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-1.
3. Close the fuel shut-off valve on fuel tank. See Fuel Shut-Off Valve, Section 14, Page 14-27.
Page 16-6
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
86
88
87
85
83
Figure 16-8 Differential Axle and Wheel Hub Assembly
90
89
Unitized Transaxle Removal
TYPICAL
95
8 PLACES
94
92
Advertisement
Table of Contents
Troubleshooting
