Table of Contents
Advertisement
6. The work are should enjoy enough light to secure the
operators can observe each details of the operation.
Besides the operator, when the machine is run-
ning, any other personnel should not in the work area.
5.2
Fix of the machine
1. Detach the bolts and nuts fixed on the machine
chassis. Bind the hoist tape (mod. DR 750 of 3m and
DR 735 of 1.5m factor 6:1).
2. Lift up the machine.
3. Take out the pallet and position at the preselected
location.
Pay attention that the nozzle and air hose on
the machine should not be damaged during the process
of hoist. Pay more attention when hoist up the machine.
When inflate the tire on the turntable, you must
fix the machine on the ground.
4. Use the M10 bolt grade 12.9, via the hole at the pal-
let, to fix the machine on the ground.
5.3
The connection of the air supply and
power supply to the machine
1. Connect the machine to the electrical circuit. As
per the electrical power specification, the electrical
circuit must be equipped with the fuse and perfect
grounded earth wire and also a protective switch will
be connected.
Note: If the machine is lack of the plug, the user should
prepare a 16A plug adapted to the machine's operation
voltage as per the electrical power norm.
R
The voltage deviation should be 0.9-1.1 time of rated
voltage range, and the frequency deviation should be
0.99-1.01 time of rated frequency range. You should
take the necessary protective methods.
R
There must be professional personnel to be respon-
sible for the connect of the electrical circuit.
R
The electrical net in the working area should be relia-
ble grounded.
Robert Bosch GmbH
Installation | TCE 260 | 11
R
When you do not use the machine, please switch off
the power supply in time to secure the machine not
to be used accidently.
R
If the machine will not be used for a long time and
the machine is directly connected to the electrical
cabinet not via a plug, the electrical cabinet should
be locked. Only the professional personnel can open
it to secure the machine not to be used accidently.
Warning
The machine must be grounded and do not connect the
earth wire to the heater, plumbing and telephone cable
etc.
2. Secure the compressed air supply comply the requi-
rement of the machine. The details of these require-
ments are specified in chapter "Technical parame-
ter". The pressure and flow of the air supply should
meet the requirement of using the machine. And the
pressure ranges from 8 to 16 bar.
3. Use the special air hose to connect with the water
separator, air regulator and lubricator at the side
of the machine. Please see the figure. Please make
sure that the oil has been fully filled reaching the
standard oil level. The oil contained in the lubrica-
tor should be SAE20 oil, or the air route will not be
lubricated and the sealing kits will be damaged in a
short time.
R
The user must mount a air supply cut off valve and
pressure regulation valve in front of the machine.
en
|
1 987 AT7 374
2015-09-02
- Quick Links:
- Technical Parameter
- Machine Diagram
- Maintenance
Hide quick links:
Advertisement
Chapters
Table of Contents
