Table of Contents
Advertisement
Bosch Motorsport
3.3 Pit Stand Installation
The pit stand antenna available from Bosch Motorsport is a dual 4G MIMO antenna with
3G fallback, both MIMO antennas are in the same housing. This antenna should be in-
stalled in an open location not obstructed by carbon fiber or metal objects.
Pit stand harness specifications
Min Supply Voltage
Max Supply Voltage
Power Consumption
Power Mating Connector
Power Mating Connector Pinout
3.4 Safety Notices
CAUTION
Disconnect power before handling of the antenna.
CAUTION
Keep a minimum safety distance of 5 cm from the human body to
the antenna.
3.5 Antenna Installation
When installing antennas, ensure that you are not spinning the cable or antenna body rel-
ative to the LTE65. To tighten the SMA connection, only turn the collar of the cable or an-
tenna. Spinning the entire cable or antenna can lead to damage of the internal co-ax
cable of the LTE65 and reduced RF performance. It is also recommended to tighten the
SMA connections to 3 in-lbf (0.3 Nm). SMA specific torque wrenches are available from
many retailers.
3.6 Receiver Ethernet Connection
Note that an LTE65 receiver must be plugged directly into a computer and not into a
switch or router. USB to Ethernet adaptors are ok to use with the computer. When the
device is used as a receiver with an Ethernet connection it will act as a DHCP server and
assign an IP to the connected computer. The default configuration for LTE65 IP and DHCP
is 10.10.0.235/24 with a lease range from 10.10.0.65-69.
Static IP addresses are not recommended as the LTE65 receiver may not reliably detect
the IP of the connected laptop.
Telemetry_System_LTE65_Manual
8 V DC
18 V DC
6 W
DTM06-2S
1=Bat Pos, 2=Bat Neg
Installation | 3
9 / 28
- Quick Links:
- Led Status Lights
Hide quick links:
Advertisement
Table of Contents
