Table of Contents
Advertisement
Available languages
Available languages
3 Faults – what to do?
B efore you call customer service, use this table to check whether you can rectify the fault yourself.
F a u l t s – w h a t t o d o ?
Temperature differs greatly from the set value.
Displays do not light up.
The power plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates E....
The electronics have detected an error.
A warning signal sounds and the alarm button is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food have been placed inside the appliance. Do not exceed maximum freezing capacity.
Display flashes, warning signal sounds and alarm button is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food have been placed inside the appliance. Do not exceed maximum freezing capacity.
Display flashes.
The temperature in the freezer compartment was too warm.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
It is too warm or too cold in the cool-fresh compartment.
The standard setting has been set too high or low (e.g. there is frost in
the cool-fresh compartment).
--------
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 13
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follow-
ing day.
Connect the power plug.
Check the fuses.
Check whether the power is on.
Please contact customer service.
~ "Customer service" on page 24
Press alarm button. Alarm is switched off.
Close the appliance door.
Clear the ventilation openings.
Press alarm button. Alarm is switched off.
Close the appliance door.
Clear the ventilation openings.
After the alarm button is pressed, the warmest temperature reached
in the freezer compartment is displayed for 5 seconds. Press alarm
button. The display stops flashing.
Start the appliance self-test.
~ "Appliance self-test" on page 24
When the program has ended, the appliance switches over to normal
operation.
You can set the temperature in the cool-fresh compartment to any-
where between+37°F and +27°F (+3°C and –3°C). The temperature
in the cool-fresh compartment is set to +32°F (0°C) by default.
Press and hold super refrigerator compartment button until the
1.
refrigerator compartment temperature display flashes.
Press ¾/¿ refrigerator compartment button to change the set-
2.
ting.
The set temperature is saved after one minute.
Faults – what to do? en-us
23
Advertisement
Chapters
Table of Contents
