Table of Contents
Advertisement
WARNING!
Ignoring the following instructions can cause physical injury, or damage to the
equipment:
• Use extreme caution when maneuvering a supply module that runs on wheels.
The modules are heavy and have a high center of gravity. They topple over
easily if handled carelessly.
• When removing a module which is equipped with wheels, pull the module
carefully out of the cubicle along the ramp. While pulling on the handle, keep
a constant pressure with one foot on the base of the module to prevent the
module from falling on its back.
• When replacing a module, push the module up the ramp and back into the
cubicle. Keep your fingers away from the edge of the module front plate to avoid
pinching them between the module and the cubicle. Also, keep a constant
pressure with one foot on the base of the module to prevent the module from
falling on its back.
• Do not tilt the module. Do not leave the module unattended on a sloping floor.
• Do not use the module pull-out ramp with plinth heights of over 50 mm.The
ramp supplied with the drive system is designed for a plinth height of 50 mm
(the standard plinth height of ABB cabinets).
max.
Support the top and bottom
of the module while remov-
ing!
Do not tilt!
Maintenance 91
Do not leave the module
unattended on a sloping
floor!
- Quick Links:
- Lcl Filter Module (Type Blcl-1X-X for...
Hide quick links:
Advertisement
Table of Contents
