Download Print this page

Husqvarna PG680 Programming page 10

Frequency inverter

Hide thumbs Also See for PG680:

Here you will find a box enabling you to change the COM Port setting. Change

the COM Port setting to number "8" or below and not already in use. Then click

"OK" twice so you exit back to Device Manager. The new COM Port setting

that you have selected for ATEN USB to Serial Bridge should now be visible.

This is the COM Port setting you need to select in NCLoad and NCDrive.

Note:

For each future software installation into the frequency inverter you perform, it

is important you insert the USB to Serial port adapter into the same USB port in

your computer / laptop. If you insert into a different USB port, Windows will

assign it to a different COM Port setting in which case you will need to change

the COM Port setting in NCLoad & NCDrive and possibly also in Device

Manager.

Once you have finished checking the COM Port setting above, continue with

COM Port selection in NCLoad.

Once the Programming file and COM Port have been selected then click

"Start".

Pg820