Table of Contents
Advertisement
Available languages
Available languages
en
36 | Start Line WBE 260 | Balancing the wheel
7. Pull out the rim-distance gage. If window B displays
"――口" and if the warning tone sounds, the point
directly on the head of the rim-distance gage is the
balancing position.
8. Continue rotating tire manually to secure other bal-
ance weights behind the spokes.
Repeat steps 5 and 6.
8.4
Attaching the clip-on weights
i
To attach the clip-on weights, you need to use coun-
terweight pliers.
Fig. 23:
Balance weight pliers
a. Balance hammer jaw
b. Hammerhead
c. Hook rolling groove
d. Metal shears for removal of metal
1. Find balancing position, then take off clip-on
weights.
2. Fixed the clip-on weights to rim with hammerhead.
i
The pliers end of the counterweight pliers is needed
to remove balance weights.
i
Carefully remove the tire on completion of all bal-
ancing work to prevent collision impact with flange
shaft.
|
1 695 600 539
2016-07-22
8.5
Attaching adhesive balance weights
!
Remove all weights using adhesive balance weight
remover. To prevent damage to the rim, do not use
any other sharp objects for this job.
1. Set required number of balance weights on head of
rim-distance gage.
2. Extract rim-distance gage once window B displays
"――口" and the warning tone sounds.
3. Rotate rim-distance gage, fit it closely to the tires,
then attach weights to the rim.
4. Repeat process for the adhesive balance weight and
repeat the 2nd balancing plane.
Fig. 24:
Balancing plane 1 – Attach the adhesive balance weights
Fig. 25:
Balancing plane 2 – Attach the adhesive balance weights
- Quick Links:
- 11. Faults
Hide quick links:
Advertisement
Chapters
Table of Contents
